MFlenses - デジタル時代の新しさ
MFLenses 2026

マニュアルフォーカスレンズフォーラム

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。
スポットライト

フォーラムトップページのおすすめパートナー掲載。

Sigma Mini Wide: interchangeable mounts
前のトピックへ :: 次のトピックへ  


Reply

This might be helpful to someone. Mounts on Sigma Mini Wide lenses can be switched. Each lens is made to support different mounts. Aperture ring has different scales to be shown in transparent window, even orientations. At least for 4 different mounts. Quite a genius of Japan economical engineering. My switch was from Contax/Yashica to Olympus OM which i needed mint to supplement SLR camera. Perhaps this is valid for other focal lengths too (i cannot verify).


Reply

Any pictures?

Seems like an interesting idea, I think other lenses have been talked about before supporting something like this.


Reply

Do Sigma Mini-Wide II mounts fit Sigma Mini-Wide I lenses?


Reply

Three different systems but the ring at the bottom attached with screws is specific to Pentax (From the Sigma 28-50mm 1:2.8-3.5) There are three aperture scales on the ring. The one used lines up with the corresponding scale below (on the other side here because it is Pentax)



Reply

[quote="D1N0"]Three different systems but the ring at the bottom attached with screws is specific to Pentax (From the Sigma 28-50mm 1:2.8-3.5) There are three aperture scales on the ring. The one used lines up with the corresponding scale below (on the other side here because it is Pentax)


To complement D1n0's photo, this is internal situation where there are 4 different aperture slides. Aperture ring can be turned around 360 degrees to match the selection. Mounts fit accordingly. The calculation for this was high level. Don't know if Mini Wide II version still sponsors such option.