MFlenses - デジタル時代の新しさ
MFLenses 2026

マニュアルフォーカスレンズフォーラム

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。
スポットライト

フォーラムトップページのおすすめパートナー掲載。

Kentmere 400 developing times
前のトピックへ :: 次のトピックへ  


Reply

It seems that very little info is available about this film, outside of the Ilford developers.
Even the Massive Development Chart does not feature it, apparently.
I'm going to try with a time of 9'30'' with Gradual ST20, based on the alleged similarity with the
developing times of the Ilford Delta 400 - which is, however, a different type of film.
And, keep my fingers crossed.
It is quite strange this lack of information, considering that the film is affordable and, apparently,
quite popular.


Reply

Had you found this info sheet, Orio?

http://www.kentmere.co.uk/Webfiles/20091291714152280.pdf

and I don't know if what this photographer noted under his photo helps:

http://www.flickr.com/photos/40150610@N02/4252397728/


Reply

Thanks Skida, yes I have the PDF, unfortunately I have none of the developers listed.
I also saw that photo, frankly the photo is so contrasted that it's difficult to tell if the developing time was correct or not.
In such backlight with presumably 5 or even more stops difference between highlights and shadows, I think any developing time
would have been equally success or failure Rolling Eyes not really matter...


Reply

Kentmere films are rebadged ilford. Treat them like fp4 and hp5 as that is what they are.


Reply

iangreenhalgh1 氏の書き込み:
Kentmere films are rebadged ilford. Treat them like fp4 and hp5 as that is what they are.


Ian, I have read contrasting opinions about this identity on the web.


Reply

I can tell you 100% for sure that in the past, Kentmere was fp4 and hp5, but that was a long time ago, I don't know if it is still the same, sorry, I should have added that caveat.


Reply

I developed the roll with Gradual ST20 for 9'30'' at 20°C, which is the recommended time for Delta 400.
It's in fact quite there with the Kentmere, although a little thin, I think 10' would be better.
The roll is drying, tomorrow I'll show some samples.