MFlenses - デジタル時代の新しさ
MFLenses 2026

マニュアルフォーカスレンズフォーラム

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。
スポットライト

フォーラムトップページのおすすめパートナー掲載。

Help with Canon T50
前のトピックへ :: 次のトピックへ  


Reply

Hi everyone !
I have this old Canon T50 camera. I don't know if it works and I would like to try to turn it on, but the mode dial is broken (it is detached and the internal plastic is slightly damages, so it does not screw ...).
Do you have any suggestions to fix it or to try to turn it on without it ?
Thank you in advance !

#1


#2


Reply

Aldo1926 氏の書き込み:
Hi everyone !
I have this old Canon T50 camera. I don't know if it works and I would like to try to turn it on, but the mode dial is broken (it is detached and the internal plastic is slightly damages, so it does not screw ...).
Do you have any suggestions to fix it or to try to turn it on without it ?
Thank you in advance !


Looks pretty nasty to me - the broken shaft probably was caused by brittle plastics (loss of plasticizers after 40 years ...) and / or a stuck internal mechanism. Since the Canon T50 was the cheapest Canon SLR in the entire SLR series, I wouldn't spent time / money trying to repair it (you would need a "new" mode dial anyway).

S


Reply

stevemark 氏の書き込み:
Aldo1926 氏の書き込み:
Hi everyone !
I have this old Canon T50 camera. I don't know if it works and I would like to try to turn it on, but the mode dial is broken (it is detached and the internal plastic is slightly damages, so it does not screw ...).
Do you have any suggestions to fix it or to try to turn it on without it ?
Thank you in advance !


Looks pretty nasty to me - the broken shaft probably was caused by brittle plastics (loss of plasticizers after 40 years ...) and / or a stuck internal mechanism. Since the Canon T50 was the cheapest Canon SLR in the entire SLR series, I wouldn't spent time / money trying to repair it (you would need a "new" mode dial anyway).

S


Ok, thank you


Reply

I think you can remove the top cover. Difficult part is the rewind knob - just do not close the back door while it is removed. Then you can see the damage inside and asseess if it is fixable.