MFlenses - デジタル時代の新しさ
MFLenses 2026

マニュアルフォーカスレンズフォーラム

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。
スポットライト

フォーラムトップページのおすすめパートナー掲載。

Olympus mju-II light seals
前のトピックへ :: 次のトピックへ  


Reply

I bought this camera recently at a local flea market.
Seems to work nicely, but on the side where the camera opens it lets in some light.
#1

#2

#3

Below is a photo of the camera and I found the latch (circled in red) was broken and the the door would not
close tightly on the bottom, thus causing the leak.
Any suggestions where to put some foam or what to do? I would like to fix it and sell it, if it would be worth it.


Reply

It seems to leak on the other side as well


Reply

!Karen 氏の書き込み:
It seems to leak on the other side as well

Your right! I didn't notice that. On most of the photos it doesn't show up though.
Maybe it's coming through the window on the back of the camera.


Reply

http://www.hobbycraft.co.uk/black-self_adhesive-fab-foam-sheet-a4/571989-1000?pn_rty=%20sp

http://www.hobbycraft.co.uk/black-self_adhesive-felt-sheet-a4/572837-1000

I make light seals from this self adhesive foam and felt sheet that I get from Hobbycraft, but it is widely available on ebay and Amazon. The foam and felt can be cut with a very sharp craft knife, but a rotary blade cutter is far better. I cut 1mm wide strips easily.

On cameras like your Olympus with the horrible sticky foam around the little window, I often use felt instead. The felt is very good and doesn't shed fibres.


Reply

Thank you! Forgot to reply.