MFlenses - デジタル時代の新しさ
MFLenses 2026

マニュアルフォーカスレンズフォーラム

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。
スポットライト

フォーラムトップページのおすすめパートナー掲載。

Fungus?
前のトピックへ :: 次のトピックへ  


Reply

Is this fungus? The lens (CZJ 300/4) still works very well, though quality deteriorates more than expected with 2x extender (this irregularity is in the center of the lens) and occcasionall bokeh highlights are not as good as they should.



Reply

Looks like it, but it can be anything, really...


Reply

LucisPictor 氏の書き込み:
Looks like it, but it can be anything, really...


I just spent a couple of hours trying to open the beast up. My attempt was a failure. One can say anyting about the east block, but at least their stuff handles abuse well Wink I only managed to get a few screws off the lens, that's it. I coul'd not open the mount, nor could I go forward from the other end. Impossible lens to open without a sledgehammer. Hmm, now that I think of it, a sledgehammer probably would not make a dent.

I really want to open the monster to clean it up, any ideas?


最終編集: Anu、日 5月 31, 2009 12:28 pm、計 1 回


Reply

Doesn't look so much like fungus, but I'm not really sure what else it could be!!


Reply

It doesn't really looks like fungus, IMHO, i would say coating/lens scratches, instead ...

If this is on the front element, try removing the front name ring ... Maybe you will be able to remove the front element this way, and (try to) clean it ...


Reply

I think these could be coating marks with early fungus or some slight damage caused by higher humidity.


Reply

indianadinos 氏の書き込み:
It doesn't really looks like fungus, IMHO, i would say coating/lens scratches, instead ...

If this is on the front element, try removing the front name ring ... Maybe you will be able to remove the front element this way, and (try to) clean it ...


Not on the front element, somewhere inside, only on one element. To me it doesn't look like scratches, as it is like closeups of ice or snow flakes or something like that.

I tried to remove the front ring - no luck, it's totally stuck. The riing holding the front element I could take off, but only if the front ring moved first. Not fun Sad


Reply

Don't clean it, most people doing wrongly try to clean immediately a lens if see anything what looks like fungus.

Why not clean ?

- it is not impact picture quality
- if you store right fungus not growing
- not infect any other lenses
- with clean you will remove coating
- if you are not professional you will risk lens safety..

Clean only if fungus impact picture quality, other ways don't.


Reply

Attila 氏の書き込み:
Don't clean it, most people doing wrongly try to clean immediately a lens if see anything what looks like fungus.

Why not clean ?

- it is not impact picture quality
- if you store right fungus not growing
- not infect any other lenses
- with clean you will remove coating
- if you are not professional you will risk lens safety..

Clean only if fungus impact picture quality, other ways don't.


I agree.

What else?

USE THE LENS

It's one of the better way to stop fungus.

Rino.[/b]


Reply

Attila 氏の書き込み:
Don't clean it, most people doing wrongly try to clean immediately a lens if see anything what looks like fungus.

Why not clean ?

- it is not impact picture quality
- if you store right fungus not growing
- not infect any other lenses
- with clean you will remove coating
- if you are not professional you will risk lens safety..

Clean only if fungus impact picture quality, other ways don't.


Thank you for the advice. I will follow it and forget about opening the objective (besides, I don't have a suitable powertools to open it Wink ). And I'm going to go out in 15 minutes to do some weightlifting with the lens. Luckily I do have a monopod.


Reply

It looks like scratches to me. The lines are too straight or sharply angled and one carries on in the same direction after discontinuing for a while, as if the pressure on the object causing the scratch eased momentarily. The rough edges would be caused by flaking at the edge of the scratch.


Reply

I was a bit apalled by the lens performance the other day, and decided to try one more time to open it. This time I got the front elements loose and out, and also managed to drop the aperture blade-unit to the ground. During the next several hours I managed to rebuilt the aperture mechanics (after major cleaning operation) maybe four times, but didn't figure out a good way to place the unit back into the lens - any ideas, anyone?

I also did some lens cleaning and I now think that the "fungus" is most likely scrathes in the coating or something like that. After frustrating hours of trying to put the aperture back into the objective, I decided to forget about it for now, and just assemble the lens without the aperture-unit. After all, the aperture wasn't functional before anyhow, and I didn't buy f/4-lens to use it at f/32 Wink

Now the lens works better than before - it can actually be used with a teleconverter now, though the "fungus" does crete some very slight vertical stripes into bokeh circles, but I can live with that. Especially, since I don't usually use a converter.

Here is a sample image taken wiith a soviet 4-element 2x teleconverter. The crop is from the bottom of the frame and it is sharpened.