MFlenses - デジタル時代の新しさ
MFLenses 2026

マニュアルフォーカスレンズフォーラム

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。

修理ノート、実際のテスト写真、画像豊富な詳細アーカイブスレッドから、ヴィンテージレンズの世界を探検してください。
スポットライト

フォーラムトップページのおすすめパートナー掲載。

Shaving adapters, techniques?
前のトピックへ :: 次のトピックへ  


Reply

Hi all. I have in my hands a fine example of a Topcor Topcon 58/1.4. Wishing to mount it on my Sony A900, I have a chipped M42-A adapter I intended to replace the back plate of the Topcor with. As it turns out, keeping the back plate is necessary but stripping protrustions away was no problem and it now sits flush with my adapter, but it needs a fraction of a mm shaved from the adapter to reach infinity this way.

I'm wondering if anyone has done something like this and can recommend a way to slowly shave away an even amount from the adapter? I was thinking of sticking a belt sander in a vice grip and holding it to the thing carefully... is there is a real way to shave metal down?

Thanks,


Kelly.


Reply

Not perfect, but perhaps better, put a piece of flat grinding paper on a glass plate (smooth surface). Then gently move the apapter on the grinding paper, up and down, left to right...
A small amount of water on the paper will help the grinding process.
I usually start with grinding paper for metal work 180, then 400 and 600 (finer for the finish).